ABB REL 551 2.3 Series - Page 125

119
Time delayed overcurrent protection
(TOC)
&KDSWHU
9HULI\LQJVHWWLQJVE\VHFRQGDU\
LQMHFWLRQ
 7LPHGHOD\HGRYHUFXUUHQWSURWHFWLRQ72&
Prepare the terminal for verification of settings as outlined in section “Preparing for
test” in this chapter.
To verify the settings the following fault type should be tested:
• One for a phase-to-earth fault
Ensure that the maximum continuous current of the terminal does not exceed four times
its rated value.
 0HDVXULQJWKHRSHUDWHOLPLWRIVHWYDOXHV
 7LPHGHOD\HGSKDVHRYHUFXUUHQW
3URFHGXUH
 ,QMHFWDSKDVHFXUUHQWLQWKHWHUPLQDOZLWKVWDUWEHORZWKHVHW
WLQJYDOXH
 ,QFUHDVHWKHLQMHFWHGFXUUHQWPHDVXUHGFXUUHQWLQWKH/Q
SKDVHXQWLOWKHVWDUWLQJVLJQDO72&67/QQ DSSHDUV
 6ZLWFKRIIWKHIDXOWFXUUHQW
Observe the maximum permitted overloading of the current cir-
cuits in the terminal.
 &RPSDUHWKHPHDVXUHGRSHUDWLQJFXUUHQWZLWKWKHVHWYDOXH
,3!
 6HWWKHIDXOWFXUUHQWWRDERXW WLPHVWKHPHDVXUHGRSHUDW
LQJFXUUHQW
 6ZLWFKRQWKHIDXOWFXUUHQWDQGPHDVXUHWKHRSHUDWLQJWLPHRI
WKH72&SURWHFWLRQ8VHWKH72&753VLJQDO
 &RPSDUHWKHPHDVXUHGWLPHZLWKWKHVHWYDOXHW3
 7LPHGHOD\HGUHVLGXDORYHUFXUUHQWQRQGLU
3URFHGXUH
 ,QMHFWDSKDVHFXUUHQWLQWKHWHUPLQDOZLWKVWDUWEHORZWKHVHW
WLQJYDOXH
 ,QFUHDVHWKHLQMHFWHGUHVLGXDOFXUUHQWPHDVXUHGFXUUHQWLQ
WKH/QSKDVHXQWLOWKHVWDUWLQJVLJQDO72&671DSSHDUV