ABB REL 551 2.3 Series - Page 25

19
Mounting the terminal &KDSWHU
,QVWDOOLQJWKHWHUPLQDO
3URFHGXUH
 &DUHIXOO\IDVWHQWKHPRXQWLQJDQJOHVWRWKHVLGHVRIWKHWHUPL
QDO
Use the TORX T20 screws available in the mounting kit.
 3ODFHWKHWHUPLQDODVVHPEO\LQWKHUDFN
 )DVWHQWKHPRXQWLQJDQJOHVZLWKDSSURSULDWHVFUHZV
 0RXQWLQJLQDLQFKUDFNZLWKDQDGGLWLRQDOER[W\SH5+*6
Make sure a side-by-side mounting kit and a suitable 19-inch rack mounting kit are
available before proceeding.
Assemble the two terminals by using a side-by-side mounting kit. Then mount the
brackets and install the assembled terminals in the rack as described in section
2.1
"Mounting in a 19-inch rack".