10
1MRS750500-MUM
Feeder and Machine Terminals
Operator’s Manual
REF 54_ , REM 54_
Fig. 3.1.2.-1 Adjusting display contrast
The user can also adjust the contrast by setting the “Contrast” parameter in MAIN
MENU/Configuration/MIMIC [17].
Provided the user stores the selected contrast tuning value in the non-volatile
memory (refer to section “Saving parameters” on page 26), the contrast is
automatically adjusted according to the set value after power cycling of the terminal.
3.1.3. Selecting language
Fig. 3.1.3.-1 Selection of language
To change the display language
1. In the MIMIC view at user level, press [E] for 2 s and enter the password to
access the technical level
2. Press [
↑] or [↓] to select Configuration (last item) in the MAIN MENU
3. Press [
→] to move to the Configuration menu
4. The cursor is at the first menu item, Languages, so you can move to the
Language menu by pressing [
→]
5. Press [
↓] to move the cursor to the desired language
6. Confirm the selection by pressing [E]
• After confirmation, the cursor automatically returns to the MAIN MENU
For more information about saving the parameters, please refer to section “Saving
parameters” on page 26.
conadj
E
Push
increase
decrease
and
langusel
E
C
Status
Protection
Control
Cond. monit.
Measurement
Communication
General func.
Tests
Information
Configuration
English
Languages
PARAMETER MENU
GROUP MENU
MAIN MENU
Cancel
Confirm
MAIN MENU
Configuration
Languages
To Next Page
Loading...
