ABB REM 54 Series - ALARM View; Technical Level

1MRS750500-MUM
Feeder and Machine Terminals
Operator’s Manual
REF 54_ , REM 54_
23
4.3.4. ALARM view
The ALARM view shows all the configured alarms with alarm texts. Active (not
acknowledged) control alarms are distinguished from non-active alarms by LED
indicators and user-defined alarm texts.
Fig. 4.3.4.-1 ALARM view
4.4. Technical level
The interactive communication between the user and the HMI at technical level is
based on menus that contain information for programming the terminal.
• To enter the MAIN MENU at technical level, press [E] for 2 s in the MIMIC view
at user level and enter the password if required
• To return to the user level, press [E] for 1 s in the MAIN MENU
Fig. 4.4.-1 Moving between user level and technical level
R
L
F
R
L
C
E
I
0
alarmvie
C clears alarms
EVENT MIMIC
CB spring ready
SF6 gas density
Temperature
Interlocking
[C] button functions in the ALARM view
• If there are active indications, press [C] for
2 s to reset
• When there are no active indications, press
[C] for 2 s to acknowledge alarms
• The acknowledgement proceeds according
to the configuration
21 kV
CB OK
AROFF
1 s2 s
levelcha
Main menu
Note ! Password 3
can be used, if
wanted, when
entering the Main
menu (see chapter
4.2)
Changing level
MIMIC view
User level
Technical level
Status
MAINMENU
Protection
Control
Cond. monit.
Measurement
Communication
General func.
Tests
Information
Configuration