1MRS750500-MUM
Feeder and Machine Terminals
Operator’s Manual
REF 54_ , REM 54_
5
1. About this manual
1.1. Copyrights
The information in this document is subject to change without notice and should not
be construed as a commitment by ABB Oy. ABB Oy assumes no responsibility for
any errors that may appear in this document.
In no event shall ABB Oy be liable for direct, indirect, special, incidental or
consequential damages of any nature or kind arising from the use of this document,
nor shall ABB Oy be liable for incidental or consequential damages arising from
use of any software or hardware described in this document.
This document and parts thereof must not be reproduced or copied without written
permission from ABB Oy, and the contents thereof must not be imparted to a third
party nor used for any unauthorized purpose.
The software or hardware described in this document is furnished under a license
and may be used, copied, or disclosed only in accordance with the terms of such
license.
Copyright © 2004 ABB Oy
All rights reserved.
1.2. Trademarks
Registrations and trademarks used in this document include:
Echelon: Registered trademark of Echelon Corporation Inc.
LonWorks: Registered trademark of Echelon Corporation Inc.
1.3. General
This document, Operator’s Manual for RE_ 54_, instructs how to use the graphic
HMI of the REF 54_ and REM 54_ terminals.
Please note that the HMI views in the pictures of this manual are exemplary.
To Next Page
Loading...
