6
1MRS750500-MUM
Feeder and Machine Terminals
Operator’s Manual
REF 54_ , REM 54_
1.4. Document revisions
1.5. Safety information
Version Date History
E 16.10.1998 Text added/changed in sections: “Button introduction”, “Setting a
parameter”, “Saving parameters”
E 11.3.1999 Text added/changed in section “Acknowledgement and resetting of
LED indicators, indication messages, outputs and registers”
F 21.2.2000 Text added/changed throughout the manual
Section “LED indicators” added
G 3.5.2002 Section “IRF test” added
H 4.6.2003 Section “Emergency stop function” added
Text added to sections “Self supervision (IRF)” and “Main window”
H 25.3.2004 Layout changed
H 25.5.2004 Layout changed
K 15.8.2004 Text and pictures updated throughout the manual
Dangerous voltages can occur on the connectors, even though the
auxiliary voltage has been disconnected.
National and local electrical safety regulations must always be
followed.
The device contains components which are sensitive to electrostatic
discharge. Unnecessary touching of electronic components must
therefore be avoided.
The frame of the device has to be carefully earthed.
Only a competent electrician is allowed to carry out the electrical
installation.
Non-observance can result in death, personal injury or substantial
property damage.
Breaking the sealing tape on the upper handle of the device will result
in loss of warranty and proper operation will no longer be guaranteed.
When the plug-in unit has been detached from the case, do not touch
the inside of the case. The relay case internals may contain high
voltage potential and touching these may cause personal injury.
!
To Next Page
Loading...
