ABB | SACE Emax 2
6 | © 2018 ABB | 1SDH001316R0002 - ECN000086018 - Rev. C Ekip Touch protection trip unit | 1 - Layout of the interface
Ekip Touch protection trip unit
1 - Layout of the interface
Components of the interface
The operator interface for the Ekip Touch trip units appears as follows:
L1
U12
528.9A
95.3V
U12 U31 L1 L2 L3U23 Ne
03:55
A
B
C
D
E
F
G
Figure 2
The following table provides a description of the parts of the interface:
Pos. Description
A Touchscreen display.
B Power LED, green.
C LED Warning, yellow.
D LED Alarm, red.
E The HOME key accesses the main page, or the initial page.
F
iTEST key. If the main page or a level 2 page is displayed (see below), whenever you press on it
the following pages are displayed in succession:
• List of Alarms, if there are any messages.
• Protection unit, with information on Mainboard and trip unit.
• Circuit-breaker, with information on the circuit-breaker.
• Last opening, with information on the last opening.
If the Trip Test item has been selected in the Test menu, it will execute the opening command
when pressed and held for at least 7 seconds.
G Test connector.
To Next Page
Loading...
