ABB ScreenMaster RVG200 - Mounting Dimensions and Panel Cutout

6.7 Change the channel configuration
1. At the System Configuration page, press the Channels
icon to display the I/O Groups 1(6) Channels page.
2. Press the icon associated with the required Group 1 (6)
Channels (for example ) to display the Channel 1 (01
…06) dialog.
3. Press the tab and then the icon
associated with each field to enter and configure Setup
parameters – press to accept the content at each
field.
4. Repeat for all other tabs on the Channel 1.01 (1.06) dialog
and for all other required channels.
When all fields have been configured, press to return
to the I/O Groups 1(6) Channels page then to return
to the System Configuration page.
5. Proceed to the next step (6.8) to set up the inputs /
outputs (I/O).
6.8 Set up the inputs / outputs (I/O)
1. At the System Configuration page, press the I/O icon
to open an I/O page displaying fitted I/O modules.
2. Press the icon associated with the required module to
display the dialog and fields associated with that module.
3. Configure parameters for each required module.
4. When all parameters have been configured, press to
return to the I/O page then to return to the System
Configuration page.
5. Proceed to the next step (6.9) to exit Configuration level
and save changes.
6.9 Save current configuration and exit
1. Press at the System Configuration page – a prompt
is displayed with options to Apply Changes, Export
Configuration, Return to Configuration Mode or Discard
Changes:
2. Press Apply Changes ( ) to save the current
configuration and return to the Operator page.
3. Proceed to the next step (6.10) to start recording.
6.10 Start recording (archiving)
1. Open the media door and insert the external media card
and close the door.
Recording is initiated automatically.
Note. Use the arrows to select
different Channels in the same process group.
Note. I/O modules are detected automatically.
Setup
Note. Alternative archive media can be used –
refer to the Operating instructions (OI/RVG200-EN)
for compatible media types.
Apply Changes
Export Configuration
Return to Configuration Mode
Discard Changes
System Configuration
14 CI/RVG200–EN