To Next PageTo Next Page
Need help?Do you have a question about the ABB SpiritIT Flow-X and is the answer not in the manual?
General| Category | Measuring Instruments |
|---|---|
| Manufacturer | ABB |
| Type | Spirit IT Flow-X |
| Accuracy | ±0.01% of reading |
| Communication Protocols | Modbus, Ethernet, Serial, HART |
| Approvals | ATEX, IECEx |
| Output Signal | 4-20 mA, digital communication |
| Power Supply | 24 V DC |
| Material | Stainless Steel, Aluminum |
| Applications | Natural gas, crude oil, refined products, chemical and petrochemical |
| Temperature Range | -40 to 70 °C |
Outlines the target audience and goals of the manual.
Summarizes the content of each chapter in the manual.
Explains symbols and conventions used throughout the manual.
Lists relevant European Union directives for compliance.
Specifies UL and CSA standards the product complies with.
Lists IEC standards referenced for testing and compliance.
Introduces the available models in the Spirit™ Flow-X product suite.
Describes the base flow module and its general capabilities.
Describes various enclosures for mounting Flow-X modules.
Describes the panel-mounted flow computer with touch screen.
Describes the compact panel mount flow computer with touch screen.
Describes the rack-mount model for dense flow metering systems.
Describes the single-stream DIN rail enclosure with screw terminals.
Describes the single-stream DIN rail enclosure with RJ45 connectors.
Describes the break-out board for convenient connection to signals.
Explains how modules can exchange data over Ethernet.
Discusses security features like metrological seals and tamper switches.
Details operating temperature, humidity, and installation environment.
Lists international standard calculations supported by Spirit™ Flow-X.
States that all models require 24 VDC and support redundant power.
Recommends forced ventilation for Flow-X/P and Flow-X/R models.
Describes the panel-mounted Flow-X/P and its mounting bracket.
Describes the compact panel-mounted Flow-X/C and its mounting bracket.
Details the location of connectors on various Flow-X models.
Provides pin-out details for power terminal blocks and D-sub connectors.
Explains redundant power connections and auto-fuse protection.
Details serial port configurations and RS-232/RS-485 support.
Describes the integrated 7" touch screen interface.
Explains remote operation via the embedded web server.
Describes the common layout and buttons of the GUI.
Details requirements for configuring flow modules with Flow-Xpress software.
Provides instructions for installing the configuration software.
Lists general specifications for hardware versions and other parameters.
Details analog and digital I/O specifications for the Flow-X/M module.
Details power consumption values for different enclosures and modules.
Shows front, side, and rear view dimensions for version 1.
Shows front, rear, side, and bracket dimensions for the Flow-X/C.
Displays side view dimensions for the Flow-X/R rack mount enclosure.
Shows horizontal, vertical, and rail mount dimensions for Flow-X/S.
Describes how to access diagnostic displays for digital and analog I/O.
Outlines calibration procedures for analog inputs, PT100, and analog outputs.
Details the procedure for calibrating analog input signals.
Describes the procedure for calibrating PT100 inputs.
Details the procedure for calibrating analog output signals.
