SM500F | Field mountable paperless recorder | IN/RandC/004-EN Rev. A 3
4 Entering the recorder's serial number
1. Locate the serial number label on the outside of the
recorder and note the serial number.
2. Access the configuration level as described in Section 6 of
the User Guide (IM/SM500F).
3. Access the 'Common' configuration level and select the
Setup tab. Use the and keys to select the 'Options
enabled' parameter and press .
4. Select any option from the list box and press .
5. Use the and keys to select the button next to
the 'Serial number' field. Press the key and using the
displayed keypad, enter the recorder's serial number noted
at step 1.
6. Repeat steps 4 and 5 to enter software option security
codes in the security code field for each option as required.
7. Exit the configuration level as described in Section 6 of the
User Guide (IM/SM500F), saving the configuration as the
'Current Configuration'.
8. Reset archiving as described in Section 5.2 of the User
Guide (IM/SM500F).
IMPORTANT (NOTE) The format of the serial
number is either */*****/*/* or 3K21**********.
To Next Page
Loading...
