Operation Manual / TPL65-A32 / -A33 / -A36 + TPL69-A32 / -A33
September 2014 HZTL2498_EN Revision A
Ribs (1) not in the middle at the top:
Completely remove the bearing casing insulation (2) and place a sling
around the bearing casing.
Loosen the fixing screws at the foot.
Lift the turbocharger off the engine and set it down to one side.
If support for the turbocharger is not provided or is inadequate, the
turbocharger could tip over during installation or removal and cause a
serious or even fatal injury.
Support the turbocharger at a suitable point.
If possible secure it using lifting gear.
Cover the oil connection.
© Copyright 2014 ABB. All rights reserved.
To Next Page
Loading...
