ABB TPL65-A32 - Installing the Turbocharger

Operation Manual / TPL65-A32 / -A33 / -A36 + TPL69-A32 / -A33
Removal and installation
7
Installing the turbocharger
7.3
Page 76
September 2014 HZTL2498_EN Revision A
Installing the turbocharger
7.3
 Remove cover from oil connection.
 Inspect lifting gear.
 Fasten separate lifting gear to each of two bearing casing ribs
provided for this purpose.
NOTICE
Oil orifice plate
An orifice plate is fitted in each of the two oil inlet channels in the
bearing casing. In order to obtain the required oil pressure, the diameter
of this orifice plate was individually adjusted by the engine builder.
Whenever these orifice plates are removed, or if the bearing casing, the
cartridge group or the complete turbocharger is replaced, make
absolutely sure that the orifice plate with the correct diameter is fitted in
the oil inlet channel in which the oil flows.
 Re-use existing orifice plate.
 Adapt turbocharger to suit engine.
 Tighten fixing screws in foot in accordance with engine builder's
instructions.
 Fasten gas, air and oil lines in accordance with engine builder’s
instructions.
TPL65: Version with compressor wheel cooling system
 Fit air supply line. (See also chapter Preliminary remarks / Layout and
functioning.)
 Refit removed parts of insulation.
 Plug in cable connector on speed sensor.
7.3
© Copyright 2014 ABB. All rights reserved.