ABB Turbocharger A130-M - Fitting Threaded Rods

Assembly Instructions / A130-M.. - A145-M
4 Installing the turbocharger / 4.2 Fitting threaded rods
© Copyright 2020 ABB. All rights reserved.
HZTL455311P0005_EN
Rev.B July 2020
4.2 Fitting threaded rods
Fig.4: Fitting threaded rods onto the bracket
1. Lightly oil the surfaces of the threaded rods(02) to be screwed in.
2. Screw the threaded rods into the bracket with the aid of locknuts(01).
3. Remove nuts(01) again.
Requirements for the threaded rods
Fig.5: Requirements for threaded rods
Product Diameter
Threaded rod
[mm]
Material
DIN / ISO 898
(Part 1)
Thread length
L1[mm]
Oil-cooled
L2 [mm]
Water-cooled
L2 [mm]
A130 Ø 16 / M16 10.9 / 12.9 ≥ 30 250 250
A135 Ø 20 / M20 10.9 / 12.9 ≥ 30 270 325
A140 Ø 24 / M24 10.9 / 12.9 ≥ 70 350 … 360 410 … 420
A145 Ø 30 / M30 10.9 / 12.9 ≥ 80 415 … 425 --
Table5: Requirements for threaded rods
Fastening material, scope of delivery
The threaded rods and nuts for fastening the turbocharger on the bracket are not included
in the ABB scope of delivery.
The clamping nuts are included in the ABB scope of delivery.
Page 11 / 21