—
4. Navigating HMI menu
—
4.1 Start Menu
TruONE ATS
Overviews
Main Menu Measures
Analog Meters
—
Fig. 4.1 By touching on one of Start Menu choices,
you can choose the Overviews -pages (upper left
corner), Main Menu -pages (lower left corner),
Analog Meters -pages (upper right corner) or
Measures -pages (lower right corner)
—
Fig. 4.2 By touching on Start Menu upper left
corner -image you can move to the Overviews
-pages, where you will find Switch status and
Supply info views, see the table below
System Overview (Switch status)
Shows voltages and frequencies of both supplies and the switch position.
Supply info view
Shows voltages and frequencies of both supplies.
Temperature view
Shows the HMI, device and pole temperatures.
HMI temperature indicates ambient temperature where the ATS power panel is installed, when
HMI is mounted to door.
Device temperature indicates the temperature inside the ATS controller.
Pole temperature indicates the temperature on the load side terminals.
Synchronization view (Enabled only when In-phase monitor is on)
Show the time to next sync, sync period.
—
Fig. 4.1
TruONE ATS
Overviews
Main Menu Measures
Analog Meters
S1 Connected to Load
Load Current
393 A
11:06
60s
G
TruONE ATS
System Overview
S1 Ok Not Ok S2
—
Fig. 4.2
To Next Page
Loading...
