46
1
ZENITH ZTS(D) T-SERIES 1600-3000 A & ZTSCT T-SERIES 100-3000 A
For more information, see chapter 6,
Troubleshooting.
Notice
When a parameter is changed, always go back
in the menu by pressing the home button and
confirm the change when asked.
Description of the icons
S1 Connected to Load
Load Current
393 A
11:06
60s
G
Override S1 Fail
TruONE ATS
System Overview
S1 Ok Not Ok S2
—
Fig. 4.4
The location of the small icons and the alarms.
Alarm List
On the lower edge of the screen you can
see the Alarms. If you touch on the alarm
you will get the Alarm List.
—
Fig. 4.3
By touching on the alarm indication on the lower
edge of the screen you will get the Alarm List.
Alarm List
Switch not in AUTO mode
Invalid Date
—
Fig. 4.5
After you have changed the parameter, go back in the
menu by pressing the < on the top left corner or Home key
and when prompted confirm changes by Confirm option.
The small icons in System Overview
-pages are:
On upper right corner
Indicates the amount of pages
and the page where you are at
the moment
Auxiliary voltage connected
11:06 Time
Application set up as Transformer-
Generator. Generator start-up
signal deactivated
Application set up as Transformer-
Generator. Generator start-up
signal activated
On upper left corner
60s Time delay, in Alarm list you can
see the name of delay at the
same time, e.g. Override S1 Fail
G
G
Application 2 Transformers/S1 Priority
Confirm Abort Modify
To Next Page
Loading...
