ABB Zenith ZTS T Series - 4.2 Using Main Menu and Setting Parameters

47
1
OPERATION, MAINTENANCE, AND INSTALLATION GUIDE
—
4.2 Using main menu and setting parameters
—
Fig. 4.6
By touching on Start Menu lower left corner -image
you can move to the Main Menu page of Operation,
Parameters, Measurements, Settings, Test and
About, see the table below for the selections.
TruONE ATS
Overviews
Main Menu Measures
Analog Meters
Operation Parameters Measurements
AboutTestSettings
TruONE ATS
Information
When you have changed the parameter, go
always back in the menu and confirm the
change always when asked.
Information
The default values are marked in the menu
tree by *-marking.
Password
The default password is 00001, enter the
password when prompted (see Fig. 4.1).
Password
Confirm
0 ****
—
Fig. 4.7
Enter the password when asked, choose the
right number by arrowheads and confirm, go
forward entering number after number.
Programming
Application 2 Transformers/S1 Priority
Confirm Abort Modify