Need help?Do you have a question about the ABB Zenith ZTX Series and is the answer not in the manual?
General| Poles | 2, 3, 4 |
|---|---|
| Frequency | 50/60 Hz |
| Operation | Manual or Automatic |
| Standards | IEC 60947-3 |
| Switch Type | Transfer Switch, Disconnect Switch |
| Standards Compliance | IEC |
| Rated Voltage | Up to 690 VAC |
| Voltage Rating | Up to 690 VAC |
Apply PPE and safe work practices. Installation and servicing by qualified personnel only.
Explains hazard symbols (Danger, Warning, Caution, Notice) used throughout the manual for safety.
Describes the Human Machine Interface (HMI) used for configuring parameters and operating the ATS.
Compares features of ZTX series ATS, covering voltage, frequency, time delay, and source failure detections.
Explains operation modes (Manual, Locking, AUTO) selection via slide switch and padlocking.
Explains how to configure the ATS using DIP switches on the HMI for various parameters.
Describes the free software for communication, testing, and configuration of ABB automatic transfer switches.
Lists common alarm conditions, their faults, and corresponding actions for troubleshooting.
Provides general technical specifications for power and control circuits, voltage, frequency, and impulse withstand.
To Next Page
