ABB Zenith ZTX Series - 2.1 General overview

16
1
Zenith ZTX Series ATS, OPERATION, MAINTENANCE, AND INSTALLATION GUIDE
1 Automatic transfer switch
2 Embedded ATS control unit and mechanism
3 HMI unit (ZTX DIP)
4 Slide switch (Hand - Locking - AUTO) for selection of the operation mode
5 Padlocking the automatic transfer switch to prevent automatic and
manual operation
6 Handle for manual operation
7 Position indication
8 Terminals for control circuit connections (behind the cover)
9 Place for auxiliary contact block
10 Location of product identification label
11 Programming port, only for Ekip Programming module and Ekip Connect software
—
Fig. 2.1 Automatic transfer switch, Zenith ZTX powered by TrueONE®
—
2.1 General overview
2
8 9
4
6
1
10
12
11
3
5 7