ABB Zenith ZTX Series - Mounting of the Handle, Automatic Mode

2
62
Zenith ZTX Series ATS, OPERATION, MAINTENANCE, AND INSTALLATION GUIDE
—
Fig. 9.3 Before moving to the Automatic mode, the
operating handle must set to its place. When the handle
is in its place properly, the slide switch will move to the
Locking mode automatically and the switch is allowed
to be padlocked, if needed. From the Locking mode the
slide switch can be moved to the Automatic mode
9.5.2 Mounting of the Handle,
automatic mode

Notice
When the slide switch is moved to the AUTO
position, the ATS is functioning immediately
in the automatic control mode.
2
1
3
Automatic
mode