43
1
—
6.2 Warnings
Message Reason
S1 and S2 not in sync Voltage sources are not synchronized
Voltage Not Calibrated Calibration data in power module is invalid or unavailable, contact ABB
Current Not Calibrated
Calibration data in current measurement module is invalid or
unavailable, contact ABB
Pole temperature warning Measured pole temperature is near the alarm level
Control Retry Failed transfer sequence retry activated
Auto Control Disabled Device is in manual operating mode
Local Bus Module heartbeat error
Configuration Configuration session ports are open
RTC capacitor charging
Real time clock is not yet operational, date & time setting is disabled as
long as this warning is active. RTC capacitor is charged from source
voltage (not AUX) and takes about 10 minutes.
—
Table 6.2 Warnings-list in ZTX via Ekip Connect
To Next Page
Loading...
Need help?
General
