Abit AB9 Pro - Serial ATA Connectors

Hardware Setup
AB9 Pro, AB9 2-15
2.6.2 Serial ATA Connectors
Each SATA connector serves as one single channel to connect one SATA device by SATA cable.
The disk array for RAID configuration is also provided:
• SATA1~SATA6: Available for RAID 0, RAID 1, RAID 5, or RAID 10 configuration.
(Supports up to 4 disks for RAID 0/10/5, or up to 2 disks for RAID 1) (For model “AB9 Pro”)
• SATA8~SATA9: Available for RAID 0, RAID 1, or JBOD configuration.
• SATA7, eSATA1: Available for RAID 0 or RAID 1 configuration. (For model “AB9 Pro”)
For more information on how to configure the function mode for SATA, please refer to the item
“On-Chip SATA” in the BIOS menu of “On-Chip IDE Device”.
To connect SATA device:
1.
A
ttach either end of the si
g
nal cable to
the SATA connector on motherboard.
Attach the other end to SATA device.
2.
A
ttach the SATA power cable to the
SATA device and connect the other end
from the power supply.