BIOS Setup 3-19
PS2MS Wakeup:
This item controls the PS2 mouse to wake up the system that has been powered down.
Resume by OnChip USB:
Two options are available: Disabled or Enabled. The default setting is Disabled. When set to Enabled,
any event affecting from onchip USB will awaken a system that has powered down.
VGA:
Two items available: OFF or ON. The default setting is OFF. When set to ON, any event occurring at a
VGA port will awaken a system that has powered down.
LPT & COM:
Four items are available: NONE LPT COM LPT/COM. The default setting is LPT/COM. When
set to LPT/COM, any event occurring at a LPT (printer) or COM (serial) port will awaken a system that
has powered down.
HDD & FDD:
Two items are available: OFF or ON. The default setting is ON. When set to ON, any event affecting a
hard disk drive or floppy drive port will awaken a system that has powered down.
PCI Master:
Two items are available: OFF or ON. The default setting is OFF. When set to ON, any event affecting the
PCI Master signal will awaken a system that has powered down.
Wakeup by PME# of PCI:
Two options are available: Disabled or Enabled. The default setting is Disabled. When set to Enabled,
any event affecting from PCI card (PME) will awaken a system that has powered down.
Resume by Ring:
Two options are available: Disabled or Enabled. The default setting is Disabled. When set to Enabled,
any event affecting from Modem Ring will awaken a system that has powered down.
Wakeup by Alarm:
Two options are available: Disabled or Enabled. The default setting is Disabled. When set to Enabled,
you can set the date and time at which the RTC (real-time clock) alarm awakens the system from Suspend
mode.
Date (of Month) / Resume Time (hh:mm:ss):
You can set the Date (month) Alarm and Time Alarm (hh:mm:ss). Any event occurring will awaken a
system that has powered down.
User’s Manual
To Next Page
Loading...
