To Next Page

To Previous Page

| Wallbox eMH2 – Taking the Wallbox eMH2 out of operation

Taking the Wallbox eMH2 out of operation

In case of severe malfunctions or damage to the device, you must take the Wallbox eMH2 out of opera-

tion. To do so, proceed as follows:

1 Open the housing cover of the wallbox with

the housing cover key and put it aside.

2 Open the access flap of the internal electronic

components cover.

3 Flip the pivot lever of the internal RCCB to the

0 position.

y Also flip the pivot lever of the internal MCB

to position0.

4 Close the access flap, hook the housing cover

onto the upper edge of the housing base and

lock it using the housing cover key.

5 Open your domestic power distribution box,

disconnect the power supply cable from the

electricity grid via the MCB and close the

distribution box.

The Wallbox eMH2 is no longer connected to the electricity grid and can be removed by a qualified spe-

cialist electrical contractor if required.

Other manuals for ABL Wallbox eMH2

Questions and Answers:

Need help?

Do you have a question about the ABL Wallbox eMH2 and is the answer not in the manual?

General