8. Install the UPS in a ventilated area, ideally exchanging 5 m
3
of air per hour,
because the chemical reaction during battery charging causes trace gas
production. If the batteries suffer breakage electrical arcing could occur in the
UPS interior.
9. If the product emits a strange noise or smell please immediately stop using
the product and contact your dealer for maintenance.
10. Always switch off the UPS and disconnect the batteries when relocating the
UPS. Be aware that, even when disconnected, charged batteries present a
possible electric shock hazard.
11. The UPS should be recharged every 2-3 months if unused. If this is not done
then the warranty will be null and void. When installed and being used the
batteries will be automatically recharged and kept in top condition.
12 Make sure that the AC utility outlet is correctly grounded.
13. Ensure that the input voltage of the UPS matches the utility supply voltage.
Use a certified input power cable with the correct plugs and sockets for the
system voltage.
14. To ensure safety in all applications where a UPS is hard wired to the electrical
supply, ensure that the system is installed by a qualified electrical contractor.
15. The UPS has its own internal energy source (battery). Should the battery be
switched on when no AC power is available there could be voltage at the
output terminals.
16. Make sure that the AC utility outlet is correctly grounded
17. Install the UPS away from objects that give off excessive heat and areas
that are excessively wet.
18. The battery will discharge naturally if the system is unused for a long time
19. This UPS supports electronic equipment in office, telecommunication,
process-control, medical, and security applications. Non-authorized
technicians are not allowed to install the UPS in the following areas.
a. Medical equipment directly related to human life
b. Elevators, subway systems, or any other equipment related to human
safety.
c. Public systems or critical computer systems.
20. The UPS offers a CVCF (Constant Voltage Constant Frequency) setting
function.
a. For correct setting and wiring please contact with your local utility agent.
b. Do not set it yourself or your warranty will be void.
To Next Page
Loading...
