ABS P.RIDE - Page 48

48
English
2-C PATRONE EINSTECKEN SCHRITT 3 - KLETT SCHLIESSEN
10 TRAGESYSTEM ANLEGEN
2-A PATRONE EINSTECKEN SCHRITT 1
STEP 3
Insert ABS
®
P.RIDE inflator
Check that the control module is clean before inserting
the inflator. Push the black rocker above the control
module down with one hand while pulling the seal
sleeve on the thumbrest upwards. Insert the inflator so
that the two marking lines match up. There should be
little resistance when you insert the inflator (otherwise
you may have it in the wrong position). You will hear a
click if the inflator has engaged correctly.
A system check later will check if the inflator has been
inserted correctly (see Step 5 Attaching activation
handle)
Attach the inflator to the backpack using Velcro.
STEP 4
Attach straps and belts
Put the backpack on. Adjust shoulder straps to fit your
body. The leg strap is stored in the left-hand hip strap
flap and you will need to adjust the length. Always
fasten the hip, chest and leg straps and adjust them
to fit your body. The ABS
®
P.RIDE System will only be
of use to you if the carrying system stays on your body
during an emergency! Adjust the straps so that most
of the weight of the pack is resting on your hips, rather
than being carried by your shoulders.