Setting: System
25
Start time Enter the start time.
Europe: last Sunday of March at
02:00
End time Enter the end time.
Europe: last Sunday of October at
03:00
DST gain Relative deviation between the start
and end time. Europe: 60 minutes
RS-485
Output menu
Parameter Description
VGA/HDMI
resolution
Configure the resolution of the local
video VGA/HDMI 1 output on the
recorder here.
Maintenance
Upgrade and maintenance
Parameter Description
Reboot Carry out a manual restart.
Restore Reset the recorder back to its
default factory settings. Excluded IP
parameter
Standard Reset the entire recorder back to its
default factory settings.
Export Export the device configuration and
network camera lists (programmed
cameras).
Import Import the device configuration and
network camera lists (programmed
cameras).
Update Perform a firmware update.
Protocol
Parameter Description
Filter1 Select "All" or choose a targeted
filter type. Different parameters for
Filter2 are available depending on
the selection.
Filter2 Detailed filter depending on the
Filter1 selection
Start time Set the start time
End time Set the end time
Export Export event report
Use the report function to get more information about the
system if problems occur.
Managing users
In user management, you can add new users, delete
users, and amend existing settings.
Warning
Please export the GUID file to reset your
password if this does not take place during the
initial installation.
Note
Please refer to the user guide for a detailed
description of the local user interface.
To Next Page
Loading...
