89
7.4.3.7 ABUS Link Station
The ABUS Link Station function is used for easy remote access to the ABUS device via Link
Station APP (iOS / Android). Products can be easily set up and released via QR code -
without complicated configurations in the router (no port forwarding required).
Activate the function and assign a verification code (6-12 characters, A-Z, a-z, 0-9, at least 2
different character types recommended).
The QR code can then be photographed in the ABUS Link Station APP.
Push function in ABUS Link Station APP
1. Activate ABUS Link Station function in IP camera
2. Add IP camera via QR code or 9-digit serial number part to the ABUS Link Station app
3. Enable Push Notification in APP (More / Feature Settings / Push Notification)
4. Enable "Alarm Notification" in the individual camera settings in the Link Station app.
5. Activate and configure desired detector in IP camera (motion detection, tripwire or
intrusion detection)
6. Activate "Event-controlled single-frame recording" in the IP camera under Storage / Single
image recording / acquisition parameters
7. Add Rule in Event Manager to IP Camera and select "Notify NVR / CMS" as action
To Next Page
Loading...
Need help?
General
