Abus NVR10010 - Setting: System; General information on system; System settings; Overview

Setting: System
24
Setting: System
General information on system
General system information can be displayed in this
menu, and firmware updates can be carried out. The sys-
tem management also contains the camera and user
management.
System settings
Overview
Parameter
Description
Device name
Change the device name here.
No.
Change the device ID here. This ID
is used for control via the
TVAC26000 keypad.
Further infor-
mation
Display the model IDs and firmware
versions.
Time settings
Parameter
Description
Time zone
Select the time zone in which the re-
corder is installed here. The time is
changed by the GMT zone based on
your selection.
NTP
Time synchronisation via the network
using the NTP server.
Important: The NTP time does not
recognise time zones, so the time
zone must be adjusted every time.
Server address
URL/host name of the NTP server
NTP port
Service port of the NTP server
Interval
Update interval for time synchronisa-
tion.
Manual time
synchronisation
Manual time setting
Device time
Current time set on the recorder
Set time
Enter the desired time manually
here.
Synchronisation
with computer
time
Synchronise the time with your PC
time (set time of the operation sys-
tem).
DST
Activate DST (Daylight Saving
Time). DST is required for program-
ming the summer/winter time setting.
The setting is the same for all re-
gions within Europe.
Start time
Enter the start time.
Europe: last Sunday of March at
02:00
End time
Enter the end time.
Europe: last Sunday of October at
03:00