Now select a week day for the recording set-up. To store particular time periods, enter a start and end
time. To activate the alarm input all day, select 00:00 as the start time and 24:00 as the end time.
To apply the settings for all week days, click the “Select All” checkbox. To copy the settings to certain other
week days, select the week day and click on “Copy”.
Select the recording mode for the required time period under the recording type.
You have the choice between the following recording types:
Normal: Permanent recording
Motion detection: Motion-controlled recording
Motion Alarm: Motion-controlled or alarm input-controlled recording. The camera records when motion is
detected or when an alarm is triggered.
Motion & alarm: Motion-controlled and alarm input-controlled recording. The camera records only when
motion is detected and the alarm input is triggered at the same time.
PIR Alarm: PIR sensor controlled recording
To apply the changes, click “OK” and to discard them click on “Cancel”.
To Next Page
Loading...
