88
Accept the settings by pressing “SAVE” or cancel them by pressing “Cancel”.
Advanced
Image improvements
Video display:
You can call up a preview video by pressing the “Video” button. This is helpful
for configuring the following image settings on this page.
Brightness:
Image brightness settings
Saturation:
Image saturation settings
Contrast:
Image contrast settings
Sharpness:
Image sharpness settings. A higher sharpness value can increase image noise.
You can reset the four image settings back to the factory settings by pressing
the “Standard” button.
White balance
Color hue:
You can adjust the basic settings for the color hue here. The colors will be
shown warmer or cooler according to the settings.
White balance:
Select the corresponding lighting conditions where the cameras are installed.
Exposure settings
Exposure frequency:
Auto: Automatic regulation of the exposure frequency
50: Fixed setting at 50 Hz network frequency
60: Fixed setting at 60 Hz network frequency
Fixed: The setting for the exposure frequency is determined and saved when
the settings are saved.
Automatic exposure:
Specifies the upper limit for automatic exposure.
Slow shutter:
On: Setting for a long exposure time in night mode. This results in a brighter
image in case of poor lighting conditions and is accompanied by a lower frame
rate.
Off: Setting for a normal exposure time in night mode.
Backlight compensation:
When this box is checked, the backlight compensation is activated. When this
function is activated, the display of objects in front of bright backgrounds is
improved.
Iris-Control
The iris control has influence to the image sharpness. The iris control need to be setup regarding the lens
zoom ratio. The following modes are corresponding to the following zoom ratios:
Auto: Lens setting: Zoom ratio low (wide viewing angle)
Offen Lens setting: Zoom ratio mid to max (mid to small viewing angle)
Wide Dynamic Range
Mode:
Off: The WDR function is deactivated
Auto: The WDR function is activated.
Level:
The dynamic range of the WDR function can be set in 10 levels. The function is
automatically controlled up to the maximum set value.
To Next Page
Loading...
