101
IP filter
Specific IP areas can be authorized or blocked for camera access in this configuration menu:
IP filter:
Enable or disable the IP filter function.
Filter list:
List of all filters that have been set up as well as buttons for editing the filters.
Filter type:
Preselection of whether a filter should permit or block before it is defined
using the “Add” button.
Add:
Add a filter.
Edit:
Edit a selected filter.
Delete:
Delete a selected filter.
Rule:
Individual IP: Definition of a filter for an IP address.
Network: Definition of a filter for a certain network.
Range: Definition of a filter for a certain IP address range.
The IP filter function is only enabled with user type “Operator” or “Viewer”. A user
with the “Administrator” user type always has access to the network camera.
Accept the settings by pressing “SAVE” or cancel them by pressing “Cancel”.
To Next Page
Loading...
