Accent 800 User’s Guide: NuVoice 35
Disabling and Enabling the Toolbox
When you disable the Toolbox, you can still use your vocabulary to speak, but the Tools key will not take
you from Core or your Home page to the Toolbox without entering a password.
To Disable the Toolbox
1. Select the Tools key and then select the Toolbox key.
2. Select Maint Menu.
3. Select Disable Toolbox. Under “Toolbox”, select Disable. The first time you disable the Toolbox, you
must enter a password. Type a password and select OK.
Important! Remember your password. You’ll need it when you want to re-enable the Toolbox. This
password will remain in effect the next time you disable the Toolbox.
4. Select OK and select OK again.
To Enable the Toolbox
1. Select the Tools key.
2. Enter your password and select OK.
3. Select the Toolbox key.
4. Select Maint Menu.
5. Select Disable Toolbox. Under “Toolbox”, select Enable.
6. Select OK and select OK again.
Backing up Your Vocabularies
1. Insert your flash drive into the USB port on the back of the device.
2. Select the Tools key and then select the Toolbox key.
3. Select Transfer Memory Menu.
4. Select Save One User Area and touch the user area you want to back up or select Save Entire Device
Contents.
5. Make sure the pre-set folder is a USB drive. If so, select OK. Type the file name and date (xx-xx-xx).
6. Select OK and wait for the information to be transferred. When the transfer is complete, select OK.
To Next Page
Loading...
