Access IS LSR118 - 5.1 Basic Configuration Commands

Page 22 of 77 Copyright © Access-IS 2020
5.1 Basic configuration
These commands set the device interface, connection parameters and specify the operating mode.
Table 2. Basic configuration commands
Command
Description
Default
Parameters/Range
AISINF
Selects the device interface.
When a Serial cable is used, the
configuration is overruled and AISINF0
is used.
When a USB cable is used, the
configuration AISINF0 is overruled and
AISINF1 is used.
0
0 - Serial
1 - USB serial (CDC)
2 - USB keyboard
3 - HID POS
AISBAU
Sets the baud rate for a Serial
connection.
Only used when AISINF is set to 0
(Serial).
9
0 - 300 bps
1 - 600 bps
2 - 1200 bps
3 - 2400 bps
4 - 4800 bps
5 - 9600 bps
6 - 19200 bps
7 - 38400 bps
8 - 57600 bps
9 - 115200 bps
AISSCP
Sets the connection parameters for a
Serial connection.
Only used when AISINF is set to 0
(Serial).
2
0 - 7N1
1 - 7N2
2 - 8N1
3 - 7E1
4 - 7E2
5 - 8E1
6 - 7O1
7 - 7O2
8 - 8O1
AISKBL
Keyboard localization; this defines the
Windows keyboard mapping for correct
output of characters.
Only used when AISINF is set to 2 (USB
keyboard).
0
0 - US (United States)
1 - UK (United Kingdom)
2 - IT (Italy)
3 - ES (Spain)
4 - DE (Germany)
5 - CH (Switzerland)
6 - CZ (Czech Republic)
7 - FR (France)
8 - BE (Belgium)
9 - SE (Sweden)
AISCHR
Sets the inter-character delay (in
milliseconds).
Only used when AISINF is set to 2 (USB
keyboard).
2
0–250 milliseconds
AISOMD
Indicator mode setting.
0
0 - Dumb mode
1 - Host mode
2 - Interactive mode
AISTAM
Triggers Auto mode.
Only used when AISOMD is set to 2
(Interactive).
0
0 - Normal operation
1 - Automatic untrigger
when media removed