Access IS LSR118 - 8.9 Get NFC Kernel Version; 8.10 Get Media Serial Number

Page 63 of 77 Copyright © Access-IS 2020
8.8.3 Example
This command exits sleep mode.
USB
Command:
[0x09]
Response:
[0x09][0x090][0x0]
Serial
Command:
[0x6F][0x01][0x00][0x00][0x00][0xFF][0x00][0x00][0x00][0x00]
[0x09]
Response:
[0x80][0x36][0x00][0x00][0x00][0xFF][0x00][0x00][0x00][0x00]
[0x09][0x090][0x0]
8.9 Get NFC kernel version
Use this command to retrieve the NFC kernel version of the NFC module.
8.9.1 Management command bytes
Byte
Command/Value
Comments
0
[0x0B]
Command byte
1–63
[0x00]
Unused bytes, set to [0x00]
8.9.2 Management response bytes
Byte
Response/Value
Comments
0
[0x0B]
Command echoed
1
NFC kernel major version
BCD hexadecimal value
2
NFC kernel minor version
BCD hexadecimal value
3–63
[0x00]
Ignored (61 bytes)
If both the major and minor kernel versions are [0x00], the NFC reader is not enabled in firmware.
If you believe this is in error, contact support@access-is.com.
8.10 Get media serial number
Use this command to get the media serial number. Table 20 shows the data element returned by
the reader for different types of media.
Table 20. Media types and data elements returned by the LSR118
Media type
Data element
MIFARE 1K, 4K and Ultralight
ISO14443-4 type A microprocessor card
Unique identifier (UID)
ISO14443-4 type B microprocessor card
Pseudo-Unique PICC Identifier (PUPI)