44
5. Locate the infrared (IR) window on the top of the meter.
6. Locate the IR window on either the infrared cable (computer) or PDA.
7. Put the meter on a flat surface and point the 2 IR windows toward each other.
They should be 3–10 cm apart.
8. Do not move the infrared cable (computer), PDA, or meter during the data
transfer.
9. Follow the prompts on the software.
The software program may shut off the meter automatically when the data
transfer is complete.
NOTE
• If the data did not transfer successfully, try again. Contact Roche if you still have problems.
• To make the most of the data transfer feature, you must set the time and date in the meter correctly.
infrared (IR) window
50705_05853397002_EN.indb 44 4/24/12 8:32 AM
To Next Page
Loading...
