What to do if Accucold SCIWD282 shows a high pressure switch error?
A high pressure switch error can occur due to condenser dust, fan motor failure, or an abnormal cold cycle. Remove any dust, check the fan motor, and inspect for any cold cycle abnormalities. The system should automatically return to normal operation after these actions.
Why does my Accucold SCIWD282 show a water supply error?
A water supply error occurs when the water level sensor doesn't detect water supply for 120 seconds. Check the water supply pressure and inspect the water level sensor. After these checks, the unit should resume operation.
How to fix motor restraint in Accucold SCIWD282 Dispenser?
Motor restraint can occur if the evaporator inlet/outlet temperature is -18 °C or less for 10 minutes, or due to poor water supply, agitator restraint, or ice jams from scale. Unlock any ice jams, check the water supply line, and inspect for motor restraint faults. After addressing these issues, the unit should resume operation, but will stop after 3 repetitions.
What to do if Accucold SCIWD282 displays a temperature sensor error?
A temperature sensor error is displayed when the temperature sensor is either open or shorted. Check the sensor and its attachments for any abnormalities. After repairing the sensor, you can start the operation.
Why does my Accucold SCIWD282 Dispenser show an evaporator temperature error?
An evaporator temperature error can occur if the evaporator temperature is 0 °C or more after 30 minutes during ice making, or if the evaporator temperature is over -5 °C after 30 minutes. Check for refrigerant leakage and inspect the sensor and its attachments for abnormalities. After resolving any cooling problems, resupply power to the unit.
What should I do if the Accucold SCIWD282's high pressure switch opens multiple times?
If the high pressure switch opens 3 times or more, contact a service representative. After the necessary actions are taken, the unit can be restarted.
What to do if Accucold Dispenser shows water level sensor defect?
A water level sensor defect occurs at the start of ice making if the upper and lower limits are not detected by the water level sensor for 60 seconds. The solution is to replace the water level sensor, after which operation can be restarted.
What to do if Accucold SCIWD282 displays a cover error?
A cover error indicates that the outlet cover is open. Close the cover to resolve the issue and resume operation.
What to do if my Accucold Dispenser shows a high pressure switch error?
A high pressure switch error in your Accucold Dispenser can be caused by condenser dust, fan motor failure, or an abnormal cold cycle. To resolve this: * Remove any dust. * Check the fan motor. * Check for any abnormalities in the cold cycle. If the high pressure switch opens three or more times, contact a service representative.
What to do if Accucold Dispenser shows water supply error?
If your Accucold Dispenser displays a water supply error, it means the water level sensor isn't detecting water after 120 seconds of attempted supply. Check the water supply pressure and the water level sensor to resolve this issue.
Explains Safety Alert Symbol, DANGER, WARNING, and CAUTION terms.
Lists essential precautions for operating the ice maker safely.
Covers electrical, ventilation, temperature, and location requirements for safe installation.
Details safety measures during operation, cleaning, and potential hazards.
Details electrical, refrigerant, pressure, and component specs for different models.
Specifies voltage, amperage, grounding, and outlet requirements.
Lists causes and actions for Er01, Er03, Er06, Er07 errors.
Lists causes and actions for Er13, Er14, Er15 errors.
Lists causes and actions for Er16, Er20, Er25 errors.
Provides a checklist of common problems and their troubleshooting steps.
To Next Page
General
