1.[FASTEN 1*PCS SCREW(M 4*8-B) IN P/B]
2.[FASTEN 2*PCS SCREW(M 3*6-T) IN P/B]
1.[FETCH POWER/B MYLAR PUT IT ON
SHIELD AND FASTEN 1*PCS SCREW
(M 3*6-T].
2.[FASTEN 1*PCS SCREW(M 3*6-T) IN M/B]
3.[GET THE SHIELD AT FRONTAGE OF THE
CONVEYER]
1.[GET THE SHIELD AT FRONTAGE OF
THE CONVEYER]
2.[GET PANEL AND PUT IT ON THE
CONVEYER, THEN TEAR OFF THE
INCOMING TAPE]
1.[UNCOVER PANEL PROTECTIVE FILM
AND INSPECT IF PANEL IS DIRTY OR
SCRATCHED]
2.[PASTE TYPE ON THE PROTECTIVE FILM
TO FASTEN IT]
3.[TURN LCD,TEAR OFF INCOMING TYPE]
To Next Page
Loading...
