1.[GET LCD COVER AND INSPECT ITS
APPEARANCE]
2.[ASSEMBLE LCD COVER TO BEZEL]
3.[STICK 1*PCS TAPE AT THE APPOINTED
PLACE]
1.[FETCH TRAVEL CARD, TEAR OFF 1*PCS
APPOINTED S/N FROM TRAVEL CARD AND
PASTE IT ON THE COVER]
2.[LOCK 2*PCS SCREW (F3*8-B) TO FASTEN
BEZEL AND LCD COVER]
3.[GET STAND NECK AND INSPECT IF IT IS
DIRTY AND SCRATCHED,THEN PUT IT IN
THE CONVEYER]
1.[AT FIRST CHECK IF 2*PCS SCREW IN THE
COVER IS LOST]
2.[LOCK 4*PCS SCREW (M4*10-B) TO
FASTEN STAND NECK]
1.[INSERT VGA CABLE IN VGA CONNECTOR]
2.[INSERT POWER CABLE IN POWER
CONNECTOR]
3.[GET BASE FIXTURE AND ASSEMBLE IT TO
STAND NECK]
To Next Page
Loading...
