Service and Maintenance 5-91
5. Attach the screw to secure the touchpad bracket to the upper case. Then connect the hall
sensor cable to the hall sensor board connector and secure the latch.
NOTE: Screw torque force = 1.5~2.0kgf.cm
Figure 5-136. Securing the Screw and Connecting the Hall Sensor Cable
6. Install the battery (see Battery Installation on page 5-49).
Table 5-21. Touchpad Bracket Screw
Screw Name Screw Type Torque Quantity
M 2.0 x 3.0 1.5~2.0kgf.cm 1
To Next Page
Loading...
