2-12 System Utilities
Setting a Password
Perform the following to set the supervisor password:
1. Use the ↑ and ↓ keys to highlight the Set Supervisor Password parameter and press
Enter. The Set Supervisor Password dialog box appears.
Figure 2-8. Set Supervisor Password
2. Type the password in the Enter New Password field.
NOTE:
Passwords are not case sensitive and the length must not exceed 12 characters. The
following characters may be used in a password.
IMPORTANT:
Use care when typing a password. Characters do not appear on the screen.
3. Retype the password in the Confirm New Password field.
4. Press Enter. The Setup Notice dialog box appears.
Figure 2-9. Setup Notice
A - Z Alphabets A through Z (Not Case Sensitive)
0 - 9 Numerical Characters
-Dash
= Equal Sign
[Left Bracket
]Right Bracket
.Period
, Comma
; Semi-colon
/Slash
\ Back-slash
To Next Page
Loading...
