Service and Maintenance 5-119
eDP Cable Installation
1. Route the eDP cable through the guides on the top side first, and then following with the left
side of the LCD cover. While routing the cable, make sure to attach the mylar (closer to the
CMOS and microphone module).
2. Continue to route the eDP cable through the guides on the bottom left of the LCD cover. Then
attach the mylar to secure the cable position.
Figure 5-178. Routing the eDP Cable
3. Connect the eDP cable to the CMOS and microphone module connector. Then attach the
mylar to secure the cable connection.
Figure 5-179. Connecting the eDP Cable
To Next Page
Loading...
