System Utilities 2-35
6. The system will start doing secure flash.
Figure 2-43. Start Secure Flash
NOTE:
• While flashing BIOS, do not remove the AC power source. If the warning message below
is shown, check if the AC power is plugged in.
Figure 2-44. AC Detect Error
_______________________Please do not remove the AC power!
Insyde H2OFFT (Flash Fireware Tool) Version 1.00.51.00
Copyright © 2016, Insyde Software Corp. All Rights Reserved.
Loading New BIOS Image File: Done
Loading New EC Image File: Done
_____________ __Current BIOS Model name : C5PRH
______________ _New_____BIOS Model name : C5PRH
_______________ Current System BIOS version: V1.XX
_______________ New_____System BIOS version: V1.XX
100%, 59sec
_______________ Start EC Update
_______________________Please do not remove the AC power!
Insyde H2OFFT (Flash Firmware Tool) Version 1.3u
Copyright(C) 2016 Insyde Software Corp. All Rights Reserved.
!
!
Error: Update BIOS Failed!
Fs1:\>_
#=============================================================================#
# Warning: NO AC Connected #
# This process requires AC power and a charged battery to avoid an accidental #
# power-off during an update. #
#=============================================================================#
To Next Page
Loading...
