129
6Select Array Type.
7 Configure the array properties.
8 Press Done when finish.
9 Press Y when prompted by "Do you want to create an array? (Yes/
No):".
10 Press any key to continue.
11 Now that the RAID volume is created, you can press <ESC> to exit.
Assigning Hot Spare drive
A hot spare is a hard disk drive that automatically replaces any failed drive
in a RAID volume, and can subsequently be used to rebuild the RAID
volume.
1Select Array Configuration Utility option.
2Select Add/Delete Hotspare.
3 The screen displays Select drives to assign Spare.
4 Select desired hard drive disk and then press <INS> to add it in
Assigned Hotspare drives area.
5 Press <Enter> to complete the selection.
6 Press Y when prompted by "Do you want to create a spare? (Yes/No):"
displayed.
7 Now a hot spare drive is created, you can press <ESC> to exit.
To Next Page
Loading...
