3-22 Machine Maintenance Procedures
5. Starting at ODD module slot (E), separate upper and lower cover.
6. Using a flat plastic tool, work along edges until upper and lower cover are separated.
7. Lift upper cover to remove.
Upper Cover Installation 0
1. Align upper cover to lower cover.
2. Press along edges to secure all latches.
3. Install and secure three (3) screws (A) to upper cover (Figure 3-17).
4. Connect power board FFC cable (B) and touchpad module FFC cable (C) to mainboard
(Figure 3-17).
5. Install and secure nineteen (19) screws (A) to lower cover (Figure 3-16).
6. Install HDD module.
7. Install keyboard.
ID Size Quantity Screw Type
A M2.5*6 22
To Next Page
Loading...
