3-14 Machine Maintenance Procedures
DIMM Module Removal 0
Prerequisite:
Base Door Removal
1. Push DIMM module clips (B) outwards.
2. Slide module (A) from mainboard connector (C).
3. Repeat steps 1 and 2 for remaining DIMM modules.
Figure 3-8. DIMM Modules
DIMM Module Installation 0
If there are 4 DIMM sockets in mainboard, follow the DIMM module installation
order: JDIMM3 -> JDIMM4 -> JDIMM1 -> JDIMM2. Ignoring the order causes dual
channel malfunction. Refer to Figure 5-2
1. Slide module (A) into mainboard connector (C) (Figure 3-8).
2. Press down on DIMM module (A) until clips (B) lock in place.
3. Install base door.
To Next Page
Loading...
