Machine Maintenance Procedures 3-25
USB Module Removal 0
Prerequisite:
Upper Cover Removal
1. Disconnect module FFC (B) from mainboard connector (D).
2. Remove screw (C) from module (A).
3. Remove module (A) from lower cover.
Figure 3-20. USB Module
USB Module Installation 0
1. Install module (A) on lower cover (Figure 3-20).
2. Connect module FFC (B) to mainboard connector (D).
3. Install and secure screw (C) to lower cover.
4. Install upper cover.
ID Size Quantity Screw Type
C M2.5*3 Ni 1
To Next Page
Loading...
