Machine Maintenance Procedures 3-29
10. Remove mainboard from lower cover (Figure 3-24).
Figure 3-24. Mainboard
Mainboard Installation 0
Use caution when installing mainboard. Forced installation may damage left side
connectors.
1. Install board by sliding connectors at left side of board at a slight angle into slots on left
side of lower cover (Figure 3-24).
2. Lower right side of board until edge is flush with lower cover.
3. Install and secure screw (G) to lower cover (Figure 3-23).
4. Connect Bluetooth cable to mainboard connector (A) (Figure 3-23).
5. Connect speaker cable to mainboard connector (B) (Figure 3-23).
6. Connect USB FFC cable to mainboard connector (C) (Figure 3-23).
7. Connect LAN to mainboard connector (D) (Figure 3-23).
8. Connect microphone cable to mainboard connector (E) (Figure 3-23).
9. Connect LVDS cable to mainboard connector (F) (Figure 3-23).
10. Connect DC-IN cable to mainboard connector (H) (Figure 3-23).
11. Install upper cover.
ID Size Quantity Screw Type
G M2.5*3 Ni 1
To Next Page
Loading...
