3-26 Machine Maintenance Procedures
LAN Module Removal 0
Prerequisite:
Upper Cover Removal
1. Remove adhesive from mainboard connector (C).
2. Disconnect cable (B) from mainboard connector (C).
3. Remove screw (D) from module (A).
4. Remove module (A) from lower cover.
Figure 3-21. LAN Module
LAN Module Installation 0
1. Install module (A) on lower cover. Figure 3-21.
2. Install and secure screw (D) to module (A).
3. Connect cable (B) to mainboard connector (C).
4. Install adhesive to mainboard connector (C).
5. Install upper cover.
ID Size Quantity Screw Type
D M2.5*3 Ni 1
To Next Page
Loading...
