Chapter 3 119
HDD SKU Reassembly Procedure
IMPORTANT: The procedures for replacing the CPU Fan, Thermal Module, RTC Battery, and Mainboard are
identical for both SKUs. See “Replacing the CPU Fan” on page 111, “Replacing the Thermal Module” on page 112,
“Replacing the RTC Battery” on page 113, and “Replacing the Mainboard” on page 113.
Replacing the HDD Module
1. Place the HDD in the carrier as shown. 2. Replace the four securing screws (two each side).
3. Insert the module in the direction of the arrow.
Ensure that the interface is properly connected.
4. Replace the three securing screws.
To Next Page
Loading...
