97
English
To remove a memory module:
1 Observe the ESD precautions described on page 84.
2 Lay the system on its side (components showing).
3 Press the holding clips on both sides of the DIMM slot outward to release
the DIMM (1).
4 Gently pull the DIMM upward to remove it from the DIMM slot (2).
5 If you intend to install a new memory module, proceed to the next section
for related procedure, then observe the post-installation instructions
described on page 85.
To install a memory module:
Note: DIMM slots on the mainboard must be installed only in certain
configurations. Numbers next to DIMM slots correspond to installation
sequence. DIMMs may be installed in pairs and in the correct order. See the
population sequence table on page 96.
1 Perform steps 1 and 2 of the previous section.
2 Select an empty DIMM slot.
3 Open the holding clips on the DIMM slot.
If you are replacing an existing DIMM, install the new DIMM in the same
slot where you removed the DIMM.
If you are adding a new DIMM, note that the system supports dual channel
configuration. The total size of the DIMMs installed in the channel A slots
must match the total size of the DIMMs in channel B slots.
4 Remove the new DIMM from its protective packaging, handling it by the
edges.
To Next Page
Loading...
